Fujitsu M9000 Security Camera User Manual


 
setroute(8)
System Administration 191
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
In a duplicated configuration, a takeover IP address can be used without a need
to determine whether XSCF has been switched. By setting the LAN ports of the
active XSCF unit as lan#0 and lan#1, they can be accessed with the names
lan#0 and lan#1. As default values, lan#0 is set to xscf#0 - lan#0 and lan#1 is
set to xscf#0 - lan#1.
When the XSCF unit is not duplicated configuration, the value of the lan#0 is
fixed with xscf#0-lan#0, and the lan#1 is fixed with xscf#0-lan#1.
Specifying an interface between XSCF units causes an error.
If the specified address is the same as the DSCP address, an error occurs.
To reflect routing information that has been set, execute the applynetwork(8)
command and reset XSCF.
The showroute(8) command can display the current routing information that is
set for the XSCF network.
EXAMPLES
EXAMPLE 1 Adds the routing of destination 192.168.1.0 and net mask 255.255.255.0 for
XSCF-LAN#0 on XSCF unit 0.
EXAMPLE 2 Adds the routing of destination 192.168.1.0 and net mask 255.255.255.0 for
XSCF-LAN#0 on XSCF unit 0 in the midrange server.
EXAMPLE 3 Adds the routing of destination 192.168.1.0 and gateway 192.168.1.1 for
XSCF-LAN#1 on XSCF unit 0.
interface Specifies the network interface to be set with routing
information. One of the following values can be specified:
For XSCF unit 0:
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
For XSCF unit 1 (when a duplicated configuration is used)
xscf#1-lan#0 XSCF-LAN#0
xscf#1-lan#1 XSCF-LAN#1
For takeover IP address:
lan#0 takeover IP address for XSCF-LAN#0
lan#1 takeover IP address for XSCF-LAN#1
XSCF> setroute -c add -n 192.168.1.0 -m 255.255.255.0 xscf#0-lan#0
XSCF> setroute -c add -n 192.168.1.0 -m 255.255.255.0 lan#0
XSCF> setroute -c add -n 192.168.1.0 -g 192.168.1.1 xscf#0-lan#1