Filter
Top Products
Intro(8)
System Administration 3
setlocale set the default locale of the XSCF
setlocator control the blinking of the CHECK LED on the operator
panel
setlookup enable or disable the use of the Lightweight Directory
Access Protocol (LDAP) server for authentication and
privilege lookup
setnameserver set the domain name system (DNS) servers used in the
XSCF network
setnetwork configure a network interface using by XSCF
setntp set the NTP servers used in the XSCF network
setpasswordpolicy manage the system password policy
setpowerupdelay set the warm-up time of the system and wait time before
system startup
setprivileges assign user privileges
setroute set routing information for an XSCF network interface
setshutdowndelay set the shutdown wait time at power interruption of the
uninterruptible power supply (UPS)
setsmtp set up the SMTP settings
setsnmp manage the SNMP agent
setsnmpusm specify the SNMPv3 agent’s User-based Security Model
(USM) configuration
setsnmpvacm modify the SNMPv3 agent’s View-based Access Control
Model (VACM) configuration
setssh set the SSH service used in the XSCF network. Also,
generate the host public key, and register or delete the user
public key, which are necessary for the SSH service
settelnet start or stop the telnet service used in the XSCF network
settimezone set the time zone and Daylight Saving Time of XSCF
setupfru set up device hardware
showaltitude display the altitude state of the system
showarchiving display log archiving configuration and status
showaudit display the current auditing system state
showautologout display the session timeout time of the XSCF shell
showboards display information on an eXtended System Board (XSB)