Filter
Top Products
156
English
QR34962
Troubleshooting
Check to seethe followingbefore askingfor arepair. Ifthe suggested solutionstill cannotrestore theDVD
video camera/recorder to normal, do not attempt to repair it yourself, but consult your dealer.
Power supplies
Symptom Cause and Correction
Reference
page
Battery cannot be
charged.
Is the ambient temperature too low or too high?
Charge the battery at 50-86ºF (10-30ºC).
36
Is the battery abnormally hot?
Removethe battery, leaveit fora while tocool down,then chargeit.
Is the DC power cord connected to AC adapter/charger? Unplug it.
Has the battery been unused for a long time?
Remove the battery, and then reattach it. If the battery is still not
charged, it may be dead: Purchase a new one.
* If the battery does not charge after you try the above four
procedures, it may be dead: Purchase a new battery.
Battery weakens fast Are you using the DVD video camera/recorder where the
temperature is very low?
The DVD video camera/recorder can normally be used for 40-60
minutes with a fully charged battery, but this time will be shorter at
low temperatures. Keep extra batteries on hand.
38
Battery may be dead.
The performance of battery will deteriorate if it is used for an
extended period of time or frequently: Purchase a new battery.
39
The CHARGE indicator
onACadapter/chargeris
blinking.
Is the ambient temperature too low or too high?
Charge the battery in environment where the temperature is 50-
86°F (10-30°).
The battery has possibly discharged excessively. Continue
charging: After a while, the battery will be charged to the specified
voltage, and the CHARGE indicator will light. Then the battery
charge will be completed normally.
36
Power turns off
immediately after being
turned on.
Is battery charged?
Charge it.
36
When power is turned
on, the LCD screen will
turn on and off.
Power goes off
unexpectedly.
Is Power Save set to “On”?
If the powered DVD video camera/recorder is left for as long as 5
minutes without recording or playback with “Power Save: On”
specified, it will automatically turn off to save battery power. To
restartrecordinginthiscase,setthepowerswitchto“POWEROFF”
andthensetitto“
VIDEO”.Youcanalsospecify“PowerSave:Off”
to stop automatic power off.
92
Power cannot be turned
off.
Detachthebatteryor ACadapter/chargeronce,and thenpress the
RESET button of DVD video camera/recorder: Reattach a power
supply to DVD video camera/recorder before turning it on again.