Filter
Top Products
26 EN
RECORDING
Advanced Features For Video And D.S.C. (cont.)
Dual Shooting
Lets you record images on a tape and store still images in a
memory card simultaneously. In other words, it is possible
to store still images in the memory card without
interrupting image recording on the tape.
1
Set the Shooting Mode Switch to “VIDEO”, then set
the Power Switch to “ ” while pressing down the
Lock Button located on the switch. Pull out the
viewfinder fully or open the LCD monitor fully.
2
Set “CAMERA MODE” to “DUAL” in the Menu
Screen (੬ pg. 28, 29).
3
While recording to a tape, press SNAPSHOT halfway.
A still image is displayed in the lower right corner of
the screen where the video image being recorded is
displayed.
•At this moment, if you release SNAPSHOT,
snapshot recording will be canceled.
4
Press SNAPSHOT fully. The displayed still image is
stored in the memory card.
NOTES:
●
If SNAPSHOT is pressed in the Record-Standby mode,
only a still image is stored in the memory card. Video
recording does not take place.
●
If SNAPSHOT is pressed when “DIS” is set to “ON”
(
੬
pg. 29), the Stabilizer will be disabled.
●
The Stabilizer is less effective in the DUAL mode than in
other modes.
●
Still images are stored in the memory card in VGA mode
file size (
੬
pg. 14).
●
When “CAMERA MODE” is set to “DUAL”, all Fade/
Wipe Effects and some Program AE with special effects
cannot be used (
੬
pg. 34 – 37).
●
The optional flash (
੬
pg. 83) will not light during video
recording.
Power Switch
FOCUS Button
Video image
Shooting
Mode Switch
Released position
Still image
Fully-pressed
position
Half-pressed
position
SNAPSHOT Button
Lock Button
FOCUS Ring
SNAPSHOT
Button