A-61579 February 2007 19
OCP AND TOUCHSCREEN OVERVIEW
In order to make the Kodak i1800 Series Scanner as easy to use as possible it was designed
with a full color touchscreen. All of the operator functions of the scanner are available (in several
languages) though the Operator Control Panel (OCP). This section describes the use and
maintenance of the OCP. Both the Image Address - Enabled and Image Address - Disabled
versions of the touchscreen will also be described. (The version that your site will not be using
can be ignored.)
If the instruction has not already done so, they should put the scanner in the Image
Address mode that the customer will be using. It is not expected that a scanner operator
would need, or be expected to, change between Image Address - Enabled and Image
Address - Disabled modes.
Only use your fingertip when touching the touchscreen. The touchscreen is not designed to be
used with a stylus. Use of a stylus or other instrument could damage the touchscreen and is not
covered under the scanner’s warranty or under the terms of any Service Agreement.
¾IDLE
When the scanner is first powered up, it comes to the Idle screen. At this point there are
several screens that can be entered to test the scanner and review scanner information
and logs. Scanning cannot be started until the host computer has setup the scanning
job.
Image Address – enabled Image Address - disabled
- Review the different fields of the Idle screen.