Filter
Top Products
27
e Enter “D:\install.exe” and click [OK].
The “Revio C2 setup menu” appears.
The CD-ROM drive is assumed to be drive “D”. Open “My Com-
puter” to confirm the drive letter of the CD-ROM drive on your PC.
4 When installation is finished, the “Revio C2 setup
menu” appears. Select [Yes] to restart your PC.
Your PC will restart automatically to complete the installation pro-
cess.
Note:
• Your PC has to be restarted to validate the installation.
If you select [No] and do not restart your PC immediately, be sure to restart it before connecting the
camera.
• If installation was not performed because, for example, the USB driver is already installed in your PC,
the above message does not appear and it is not necessary to restart your PC.
Connecting the camera to your PC
1 Turn on your PC and start Windows.
Do not forget to remove the CD-ROM from the CD-ROM drive.
2 Set the USB mode on the camera to “MSDC” if you want to transfer recorded
images to your PC and to “PC CAMERA” if you want to transfer the through-
image live to your PC. (Refer to the page 25)
3 Connect the camera and your PC using the USB cable provided.
4 If this is the first time to connect the camera to your PC in MSDC mode or PC
CAMERA mode, the hardware will be installed. (If you are using Windows 98,
Windows 98 SE or Windows Me)
If you are using Windows 2000 Professional, the following screen is displayed.
A warning message like the one shown on the right appears.
However, this is not a problem and you should just click [Yes]. If
you select [No], the camera will not be connected correctly to
your PC.
If you are using Windows XP, the following screen is displayed.
c The “Detect New Hardware Wizard” appears. Select “Automat-
ically install the software” and click [Next].