Konica Minolta X60 Digital Camera User Manual


 
16 17Getting up and running
BATTERY-CONDITION INDICATOR
Full-battery indicator - the battery is fully charged. This indicator is dis-
played when the camera is on.
Low-battery warning - battery power is very low. The battery should be
replaced as soon as possible. This warning automatically appears and
remains on the monitor until the battery is recharged. Movie recording is not
possible.
AUTO POWER SAVE
To conserve battery power, the camera shuts down if an operation is not made within three minutes.
To restore power, press the shutter-release button or playback button. The length of the auto-
power-save period can be changed in section 2 of the setup menu (p. 72). When the camera is con-
nected to a computer or PictBridge printer, the auto-power-save period is set to ten minutes and
cannot be changed.
This camera is equipped with an automatic battery-condition indicator displayed on the LCD moni-
tor. The indicator changes from white to red when battery power is low.
AC ADAPTER (SOLD SEPARATELY)
The AC adapter AC-4 or AC-5 allows the camera to be powered
from a household outlet. The AC adapter is recommended when
the camera is interfaced with a computer or during periods of
heavy use. AC adapter model AC-4 is for use in North America,
Japan, and Taiwan, and AC-5 is for use in all other areas. The bat-
tery cannot be charged using the AC adapter.
1. Insert the mini-plug of the AC adapter into the DC terminal.
2. Insert the AC adapter plug into an electrical outlet.
Low-battery indicator - the battery is partially charged.
If power is insufficient for camera operation, the indicator lamp above the
LCD monitor turns orange and blinks for three seconds when the camera is
turned on, or the battery-exhausted message appears on the LCD monitor
just before the camera shuts down. The shutter will not release. The battery
must be recharged.
Always turn off the camera before changing between power supplies.
Always keep the strap around your wrist in the
event that the camera is accidentally dropped.
1. Pass the small loop of the strap through the
strap eyelet on the camera body.
2. Pass the other end of the strap through the
small loop and tighten.
ATTACHING THE STRAP
2
1
1