Kyocera L3 Digital Camera User Manual


 
Basic Operations
20
Basic
Operations
Holding the Camera Steady
LED Displays after Shooting
When the caution LED and card access LED flash after shooting, the messages to be noted
are as follows:
For the LED display, see page 99
If the card access LED flashes after shooting, the images are being recorded into the
memory card.
Do not open the memory card door or remove the memory card. Doing so may cause
damage to the data. (You can take pictures while LEDs flash after shooting.)
If the caution LED flashes after shooting, the flash is being charged. Wait until the caution
LED goes before taking the next picture.
Shutter Release Button Half-way Down
When the shutter release button is
pressed, it will stop partway in its travel.
In this semi-depressed position, the
camera sets exposure and focus for
shooting. When the shutter release
button is fully depressed, the picture is
taken and recorded.
Relax your shoulders.
Hold your elbows close to
your body.
Use both hands to hold the camera.
Be careful that the lens, flash,
light sensor and viewfinder are
not covered by your hand or
fingers.
DISP.
Alarm LED (Red)
Card Access LED
(Orange)
Not pressed
Half-pressed
Fully depressed (for
recording an image)
00_8CQ.book Page 20 Wednesday, May 14, 2003 8:10 PM