Filter
Top Products
A
2. Press the shutter release button and the
emergency film wind button A simultaneously.
The film will be advanced to the end and the
magazine’s LCD panel will show “End.”
Removing a Partially Exposed Roll of Film
1. Insert the dark slide in the magazine.
D
C
A
B
39 40
6. Unloading the exposed film.
When the roll of film is completely exposed, the camera automatically advances the film
completely to the end. The LCD panel displays “End.”
1. Open the back cover.
Hold down the button A and press the button B
to the right.
2. Remove the roll-film insert.
Pinch the knobs C of the roll-film insert in the film
chamber with your fingers and take out the roll-
film insert.
3. Remove the film.
Push down the backing plate D away from the
spool, and take out the film roll.
4. Seal the film with the film tape.
Secure with the provided film tape so that the roll
will not come loose.
Caution: Checkpoints for film removal
Do not unload an exposed film in direct sunlight.
After the film has been removed from the inner frame, do not wind the film tightly.
Otherwise, pressure marks may be remain on the film.
Put the used film inside a light-proof bag, box or other container, and take it as soon
as possible to the developer’s.
Never detach the magazine from the camera body in the middle of film winding.
You can smoothly load the next roll of film, if you move the empty spool to the lower
compartment (printed “SPL”).
For the procedure to remove the film before reaching the end of the film, see page 40.
Film Tape
Taking Photos (continued)