Filter
Top Products
205
Menu Guide—Custom Settings
Custom Setting f4: Assign FUNC. Button
This option controls the function performed by
the FUNC. button. Highlight f4 FUNC. Button in
the second level of the CSM menu (
178) and
press the multi selector to the right. Press the
multi selector up or down to highlight an option,
then press to the right to make a selection.
Option Description
FV Lock/
Lens data
As above, except that when SB-800 or SB-600 is off or not attached,
FUNC. button and command dials can be used to specify focal length
and aperture of non-CPU lenses ( 128).
FV Lock
(default)
If SB-800 or SB-600 Speedlight is attached, fl ash value locks when
FUNC. button is pressed. Press again to cancel FV lock.
1 step
spd/
aperture
If FUNC. button is pressed when rotating command dials, changes to
shutter speed (exposure modes S and M) and aperture (exposure modes
A and M) are made in increments of 1 EV.
Flash off Flash will not fi re in photos taken while FUNC. button is pressed.
Same as
AE-L/AF-L
FUNC. button performs same functions as AE-L/AF-L button.
Bracket-
ing burst
While FUNC. button is pressed, all shots in exposure or fl ash bracketing
program will be taken each time shutter-release button is pressed. In
continuous high-speed and continuous low-speed modes, camera will
repeat bracketing burst while shutter-release button is held down. If
white-balance bracketing is selected, camera will take photos at up to
8 fps (single or continuous high-speed mode) or 1–7 fps (continuous low-
speed mode) and perform white balance bracketing on each frame.
Center-
weighted
Center-weighted metering activated while FUNC. button is pressed.
Matrix
metering
Matrix metering activated while FUNC. button is pressed.
Spot
metering
Spot metering activated while FUNC. button is pressed.
Hi-speed
Crop
FUNC. button and main command dial can be used to turn high-speed
crop mode on and off ( 41). Hi-speed crop mode can not be changed
after fi rst shot in multiple exposure.