Filter
Top Products
160
Troubleshooting
Technical Notes
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source as described above may result in the loss of any data not
recorded to internal memory or the memory card at the time the problem
occurred. Data already recorded will not be affected.
Shooting
Monitor turns off, and the
power-on lamp and flash lamp
blink rapidly.
Battery temperature is high. Turn off camera,
and allow battery to cool down before resuming
use. After the lamps blink for 30 seconds, the
camera will turn off automatically, but you can
also press the power switch to turn it off
manually.
17
Problem Cause/Solution A
No picture taken when shutter-
release button is pressed.
• When camera is in playback mode or menus
are displayed, press the shutter-release
button.
• Battery is exhausted.
• When flash control blinks, flash is charging.
28
22
31
Camera cannot focus. • The intended subject is one with which
autofocus does not perform well.
• Set AF assist in the setup menu to Auto.
• Focus error. Turn camera off and then on
again.
27
142
22
Pictures are blurred. • Use flash.
• Use ISO sensitivity>High ISO sensitivity
auto in the shooting menu.
• Use vibration reduction.
• Use
D
(Best Shot Selector).
• Use tripod and self-timer.
30
123
142
121
32
Bright specks appear in
pictures taken with flash.
Flash is reflecting off particles in air. Turn flash
off.
31
Problem Cause/Solution A