Filter
Top Products
For safe use of your camera
11
1
Continued on next page
Read this first
The latest high precision technology has gone into the making of the camera’s
monitor, but there are some pixels which are permanently lit or which do not light at
all. These pixels do not affect the recorded picture. Also, depending on the angle at
which the monitor is viewed, the colors and brightness may appear uneven, but this
is due to the structure of the monitor and is not a malfunction.
Precautions for handling the charger
Danger
The charger should not be used where it may come in contact with water and
it should never be connected or disconnected with wet hands.
Do not cover the charger with anything such as a cloth or blanket when in use
as this may cause overheating, resulting in fire.
Do not attempt to disassemble or modify the charger. Such action could lead to
electric shock or injury.
Use the charger at the specified voltage. Use at any other voltage could result in
fire, explosion, emission of smoke, overheating, electric shock or burns.
Warning
Prolonged contact with the charger during use
could result in low temperature burns.
Do not damage the AC cable for the charger by pulling it and do not attempt
to extend it
. Always disconnect the cable by removing the plug and not by pulling the
cable. Discontinue use of the charger immediately in the event of the following and
contact your nearest dealer or Olympus service center.
• If the plug or cable is hot, there is a smell of burning, or smoke is emitted.
• If the cable is damaged or ruptured or the plug connection is faulty.
Caution
Do not charge the battery continuously for over 24 hours. If the battery is not fully
charged when the charging time has elapsed, discontinue charging.
Before cleaning the charger, unplug the AC cable from the wall outlet. Failure to do
so could result in electric shock or injury.
Precautions when handling the battery
Danger
Keep the battery out of the reach of children.
Do not expose the battery to fire or excessive heat as this could result in fire
or explosion.
Do not use or leave the battery in places of high temperature such as in
strong sunlight, inside a car under a blazing sun or in front of a heater as this
could result in fire or explosion.
Do not attempt to directly solder the battery, change its shape, modify it or disassemble
it as this could damage the terminal safety valve or cause the battery to leak.