Filter
Top Products
160
Maintenance and Inspections: Warning System
HDD
(USB HOST
mode)
HDD CAPACITY
FULL!
Not enough space left on the hard disk. There is not enough space on the connected
hard disk. Use a new hard disk or formatted hard
disk.
TOO MANY
PARTITIONS!
There are too many partitions. Hard disks can handle up to 23 partitions. Use a
new hard disk or formatted hard disk.
HDD
DISCONNECTED!
The unit is not connected to a hard disk. Reconnect the USB cable. If the hard disk does
not operate normally, turn it off and turn it back on
again.
CANNOT FORMAT! The hard disk cannot be initialized. Connect another hard disk drive.
TOO MANY
TARGETS!
Multiple devices are connected. Disconnect devices, turn off the unit and turn it
back on again.
UNKNOWN DEVICE
CONNECTED!
The connected DVD drive is not compatible. Disconnect devices, turn off the unit and turn it
back on again.
CANNOT ACCESS
TARGET!
An error occurred during hard disk access. Check hard disk status and connection.
CANNOT
RECOGNIZE HDD!
The destination target cannot be properly
recognized.
Reboot the hard disk or connect a different hard
disk.
CANNOT ACCESS
CARD!
An error occurred during P2 card access. Check P2 card.
MISMATCH
COMPONENT!
Copying is not possible since the model number
of the destination card does not match that of the
source card.
Use a P2 card with the same model number or
import video in clip units.
P2 CARD IS
UNFORMATTED!
The P2 card is not formatted. Use a formatted P2 card.
CARD IS EMPTY!
CANNOT COPY!
The P2 card selected for copying is empty. Copying is not performed since the card is empty.
VERIFICATION
FAILED!
The compare check after copying failed. Copy the data again.
PLEASE FORMAT P2
CARD!
This warning indicates that data could not be
imported from a hard disk to a P2 card because
the P2 card contained recorded data.
You cannot copy to a P2 card that contains data.
Format the card on a P2 device and copy again.
Item Message Description Measure
AJ-HPX2700G-VQT1V27_eng.book 160 ページ ２００８年９月２日 火曜日 午後５時４３分