Filter
Top Products
NO.4 ** INITIAL **
H PHASE +....I....-
SC COARSE 0°
SC FINE +....I....-
RET END
-30-
■ COLOR PHASE ADJUSTMENT
Supply the output signal (split color bar) from the color
special effect generator to a color monitor or vectorscope.
Adjust the color phase of the camera with either the cam-
era controls or the RCU (RCB) control.
[ADJUSTMENT WITH RCU (RCB)]
Use the subcarrier phase coarse adjustment control and
subcarrier phase fine control located in the pocket.
* It is recommended that a vectorscope be used for
maximum accuracy in color phase adjustment.
[ADJUSTMENT by CAMERA]
1. Press the BAR (DOWN) switch for over 1 second for
the color bar mode.
2. Select page No.4 of INITIAL SET menu.
3. Select “SC COARSE” with the item switch. Make
coarse adjustment with the Up switch and the Down
switch.
4. Select “SC FINE” with the item switch. Perform fine
adjustment with the Up switch and the Down switch.
Magenta
Green
Cyan
Yellow
White
Red
Blue
Black
Magenta
Green
Cyan
Yellow
White
Red
Blue
Color bar of
camera
Color bar of special
effects generator