Filter
Top Products
-35-
When the mode is set to ELC, the electronic shutter
may not function if the iris is set to AUTO in the SETUP
menu and the lens iris switch to M (manual). Make
sure that the camera and lens settings are the same. If
ELC is selected, flicker may increase under fluores-
cent lights.
4 White Balance Setting [WHITE BAL: ATW, A CH, B
CH, MANU, P SET 3.2K, P SET 5.6K]
When the mode is set to ATW, white balance is auto-
matically adjusted at all times.
When the mode is set to A CH or B CH, with SETUP
menu OFF, white balance is automatically adjusted
with the AWC switch on the back of the camera. Color
temperature conditions of two scenes can be stored in
the A CH/B CH memories. When the painting mode is
ON, fine color adjustment can be made by red/blue
gain setting of INITIAL SET menu after AWC.
When the mode is set to MANU, white balance can be
adjusted by red/blue gain setting of INITIAL SET
menu.
When the mode is set to P SET 3.2K, white balance is
adjusted to 3200K illumination.
When the mode is set to P SET 5.6K, white balance is
adjusted to 5600K illumination.
Note:
When the camera is used with an RCU (RCB), the
switch cannot be set to MANU, P SET 3.2K, or P
SET 5.6K.
5 Detail Level Setting [DTL LEVEL: OFF, LOW, HIGH]
Use this mode to select any of three detail levels as
desired: HIGH, LOW, OFF.
* Low or high level ranges can be set by using a USER
SET menu.
6 Scene File Selection Setting [SCENE FILE: 1, 2, 3,
USER A, USER B]
Mode 1:
USER A/B -- User set
SCENE 1:
SCENE 2:
SCENE 3:
Mode 2:
USER A/B -- User set
SCENE 1:
SCENE 2:
SCENE 3:
Mode 3:
USER A/B -- User set
SCENE 1:
SCENE 2:
SCENE 3:
Mode 4:
USER A/B -- User set
SCENE 1:
SCENE 2:
SCENE 3:
* USER A and B have a memory for each operation
mode (8 in total).