Filter
Top Products
(4) To return to the SETUP menu state, move the cursor to
RET and press the page switch.
(5) To change gain up, move the cursor to GAIN in the
SETUP menu, and use the Up or Down switch. (This
applies in cases where the camera is used alone.)
-47-
(6) To return to the normal state, do the following steps.
If the camera is used alone, move the cursor to END,
and press the page switch.
If the camera is used with an RCU (RCB), set the user
set switch to OFF.
The camera will then operate according to the set-
tings.
RESET USER A?
(MODE1)
YES : UP SW
NO : DOWN SW
NOW RESET
USER A MEMORY
■ User Set Memory Reset
The AW-E560 has a reset function, which restores the orig-
inal settings if wrong data is entered in USER SET A or
USER SET B setting.
(1) Switch camera power off, and switch it back on.
(2) Complete the operation mode/USER file setting and
press the page switch. When the new settings for
reset are displayed, press the page switch again for
about 2 seconds while "CURR: MODE 1/USER A" is
displaying on the screen then the screen shown at
right on the top appears.
(In case of USER B, RESET USER B? appears on the
screen.)
(3) If YES is selected by pressing the Up switch within
about 10 seconds after the screen shown in Step (2)
appears, the user set memory is reset, a message
appears as shown at right, and the operation returns
to normal state.
(In case of USER B, NOW RESET USER B MEMORY
appears on the screen.)