Filter
Top Products
-40-
!5 Detecting Ratio Adjustment [PEAK/AVG]
The ratio of AUTO IRIS/AGC/ELC detected peak to
average can be adjusted in a range of 9 steps.
!6 AUTO IRIS Level Fine Adjustment Setting
[AUTO IRIS: ADJ ON/ADJ OFF]
When the mode is set to ADJ ON, fine adjustment of
ALC/ AGC/ELC convergence level can be made with
the iris VR control on the RCU (RCB) if the camera is
used with an RCU (RCB) and the iris mode is set to
AUTO in the SETUP menu.
!7 Synchroscan Adjustment
[SYNCHRO-SCAN: 1/525 to 253/ 525]
Shutter speed can be adjusted when the shutter
speed mode is set to SYNCHRO in the SETUP menu.
In shooting a monitor screen, for example, set the
shutter speed mode is set to SYNCHRO and use this
item for shutter speed adjustment so that horizontal
bar noise will be reduced.
!8 CCD Read Out Mode Setting [FLD/FRM: FIELD/
FRAME]
The position FIELD means CCD field storage. The
position FRAME means frame storage, in which case
vertical resolution increases.
FIELD: Set to this mode when shooting moving object
FRAME: Set to this mode when shooting still object
* It is recommended that the mode be normally kept at
FIELD because, if the mode is set to FRAME, residual
image will increase.
!9 Gamma Correction ON/OFF Setting [GAMMA: ON,
OFF]
Gamma correction ON/OFF can be set.
* Gamma correction level can be set using a user set
menu.
@0 2-Dimensional Lowpass Filter ON OFF Setting
[2D LPF: ON, OFF]
2D lowpass filter ON/OFF can be set to reduce cross
colors.
@1 Color Bar Setting (COLOR BAR: 1, 2, 3, 4]
Color bars can be selected.
1: SMPTE color bar with 0.0% setup
2: SMPTE color bar with 7.5% setup
3: Full color bar with 0.0% setup
4: Full color bar with 7.5% setup
@2 Horizontal Phase Adjustment [H PHASE]
Horizontal phase can be adjusted when a genlock sig-
nal is supplied.
@3 Sub Carrier Phase Coarse Adjustment
[SC COARSE: 0°, 90°, 180°, 270°]
Coarse adjustment of sub carrier phase can be made
when a genlock signal is supplied.
@4 Sub Carrier Phase Fine Adjustment [SC FINE]
Fine adjustment of sub carrier phase can be made
when a genlock signal is supplied.