Filter
Top Products
English
VQT0K98
154
During recording
Symptom Cause and Correction
Reference
page
Recording starts but
stops immediately.
Is disc scratched or does dirt or fingerprint adhere to it?
Clean the disc. If there is still no improvement, replace the disc.
70
If you turn this DVD Video Camera on for many hours in a high
temperature location, this DVD Video Camera may automatically
stop recording for the protection of the lens in the laser pickup
assembly. In this case, follow the messages on the display of this
camera. To start the recording again, turn this
camera off and leave it for a while.
Some vibrations are felt
or slight sound is heard
from mechanism.
These vibrations or sound are caused by disc drive: This does not
indicate a fault.
LCD screen is hard to
see.
Has brightness of LCD screen been adjusted?
Stop recording and adjust the brightness.
86
Is the DVD Video Camera being used outdoors?
Use the viewfinder. When using LCD monitor, adjust its angle so that
LCD screen is not exposed to direct sunlight.
35, 37
Focus is not correct. Is it difficult to use auto focus with your subject?
Focus manually.
63
Does “MF” appear?
The DVD Video Camera is set to manual focus. Focus the subject
manually, or release manual focus.
62
Is the dioptre control correctly adjusted if you are using the
viewfinder as a monitor?
Adjust the dioptre control.
35
In cases other than the above, set the power switch to “OFF”, and
then set it to “ ”, “ ” or “ ” again.
48
322
ENG.book Page 154 Tuesday, March 23, 2004 8:12 PM