Filter
Top Products
26
■ SD memory card
[SD memory card]
Select "Use" or "Not use" to determine whether or not to
use the SD memory card.
Default: Use
Important:
• Select "Not use" when operating without a SD mem-
ory card.
• Before removing the SD memory card from the cam-
era, it is necessary to select "Not use" first.
• After inserting the SD memory card, it is necessary
to select "Use" to use the SD memory card.
• When playing or downloading images saved on the
SD memory card, it is necessary to select "On" for
"Save logs" on the [Log] tab (☞ page 32) in
advance.
• When the image refresh interval is short, notifica-
tion/recording timing or interval may become incor-
rect. Notification/recording may also not be per-
formed correctly as configured when multiple users
are receiving images. In this case, set the refresh
interval longer.
• There are limited times to overwrite on an SD mem-
ory card. When having a high frequency of overwrit-
ing, the lifetime of the SD memory card may become
shorter.
[Remaining capacity notification]
When the mail notification function or the Panasonic
alarm protocol function is used to provide notification of
the remaining capacity of the SD memory card, select a
level to be notified at from the following.
50%/20%/10%/5%/2%
Default: 50%
Note:
• Notification will be provided each time the remaining
capacity of the SD memory card reached the values
above.
For example, notification will be provided each time
the remaining capacity reaches 50%, 20%, 10%, 5%
and 2% when "50%" is selected. Notification may not
always be made at the very moment when the
remaining capacity of the SD memory card has
reached each value.
Configure the settings relating to the SD memory card [SD memory card]
Click the [SD memory card] tab on the "Basic" page. (☞ pages 20 and 21: How to display/operate the setup menu)
The settings relating to the SD memory card can be configured on this page.
Important:
• It is impossible to display images and to receive/
transmit audio between the camera and the PC
when the viewer software "Network Camera View4"
is not installed on the PC.
• The number of the viewer software installations can
be checked on the [Upgrade] tab of the
"Maintenance" page.