Filter
Top Products
55
Configure the settings relating to the alarm image [Alarm]
Click the [Alarm] tab on the "Alarm" page. (☞ pages 20 and 21: How to display/operate the setup menu)
The settings relating to the alarm image to be transmitted to an FTP server can be configured in this section. The
alarm image will be transmitted to an FTP server. To transmit alarm images to an FTP server, it is necessary to con-
figure the settings in advance. (☞ page 70)
Refer to pages 54 and 57 for further information about the settings relating to the alarm action and the alarm output
terminal.
Important:
• Depending on the network line speed or the network traffic, images may not be transmitted at the exact designat-
ed interval or period.
• When "Alarm input" or "Manual" is selected for "Save trigger" on the [SD memory card] tab, images will not be
transmitted to the FTP server even when an alarm is detected. (☞ page 27)
■ Alarm image
[FTP >>]
When "FTP >>" is clicked, the [FTP] tab of the "Server"
page will be displayed. (☞ page 70)
[Alarm image FTP transmission]
Select "On" or "Off" to determine whether or not to
transmit the alarm image to the FTP server.
Default: Off
[Directory name]
Enter the directory name where the alarm images are to
be saved.
For example, enter "/ALARM" to designate the directory
"ALARM" under the root directory of the FTP server.
Available number of characters: 1 - 256 characters
[File name]
Enter the file name used for the alarm image to be
transmitted to an FTP server. The file name will be as
follows.
File name: ["Entered file name" + "Time and date
(year/month/day/hour/minute/second)"] + "Serial
number"
Available number of characters: 1 - 32 characters
[Post alarm]
• Transmission interval
Select the transmission interval for the alarm image
transmission to the FTP server from the following.
0.1fps/0.2fps/0.33fps/0.5fps/1fps
Default: 1fps
• Number of images
Select the number of images to be transmitted from the
following.
1pic/2pics/3pics/4pics/5pics/6pics/7pics/8pics/9pics/
10pics/20pics/30pics/50pics/100pics/200pics/300pics/
500pics/1000pics/2000pics/3000pics
Default: 100pics
• Recording duration
Approximate time to be taken to save the set "Number
of images" with the set "Transmission interval" will be
displayed.
[Image capture size]
Select "QVGA", "VGA" or "1280x960" for the image cap-
ture size of images to be transmitted to the FTP server
or of an image to be attached to the alarm mail.
Default: VGA
Note:
• "QVGA" is available only when "1.3 mega pixel" is
selected for "Image capture mode".