Filter
Top Products
42
Unicast port (MANUAL): Up to 14 users can access a
single camera concurrently. It is necessary to select
"Unicast port1(Image)" and "Unicast port2 (Audio)"
manually to transmit images and audio from the
camera.
It is possible to fix the port number of the router used
for MPEG-4 image transmission via the Internet by
setting "Unicast port (MANUAL)" (☞ page 74).
Refer to the operating instructions of the router in
use.
Multicast: Unlimited number of users can access a sin-
gle camera concurrently. Complete the entry field of
"Multicast address", "Multicast port" and "Multicast
TTL/HOPLimit" when transmitting MPEG-4 images
with multicast.
* Refer to page 6 for further information about the
maximum concurrent access number.
Default: Unicast port (AUTO)
[Unicast port1(Image)] *1
Enter the unicast port number (used to transmit images
from the camera).
Available port number: 1024 - 50000 (Only even num-
bers are available.)
Default: 32004
[Unicast port2(Audio)] *1
Enter the unicast port number (used to transmit audio
from the camera).
Available port number: 1024 - 50000 (Only even num-
bers are available.)
Default: 33004
[Multicast address] *2
Enter the multicast IP address.
Images and audio will be transmitted to the designated
IP address.
Available IPv4 address: 224.0.0.0 - 239.255.255.255
Available IPv6 address: Multicast address starting with
"FF"
Default: MPEG-4(1): 239.192.0.20
MPEG-4(2): 239.192.0.21
Note:
• Enter a multicast IP address after checking available
multicast address.
[Multicast port] *2
Enter the multicast port number (used to transmit
images from the camera).
Available port number: 1024 - 50000 (Only even num-
bers are available.)
Default: 37004
Note:
• When audio is transmitted from the camera, the port
number to be used will be the multicast port number
plus "1 000".
[Multicast TTL/HOPLimit] *2
Enter the multicast TTL/HOPLimit value.
Available value: 1 - 254
Default: 16
Important:
• When transmitting an MPEG-4 image via a network,
the transmitted image sometimes may not be dis-
played. In this case, refer to the network administra-
tor.
• When two or more network interface cards are
installed on the PC in use, the network interface
card(s) not used for receiving images should be
invalidated when displaying images using the multi-
cast port.
*1 It is necessary to designate the unicast port number
when "Unicast port (MANUAL)" is selected for
"Transmission type".
*2 It is necessary to designate the multicast IP address
when "Multicast" is selected for "Transmission type".