Filter
Top Products
102
Compensating Flash Output
You can change the fl ash output in a range of -2.0 to +1.0. The Flash
Compensation values are as follows for 1/2 EV and 1/3 EV.
Step interval
Flash Compensation
1/2 EV -2.0, -1.5, -1.0, -0.5, 0.0, +0.5, +1.0
1/3 EV
-2.0, -1.7, -1.3, -1.0, -0.7, -0.3, 0.0, +0.3, +0.7, +1.0
Set interval of steps in [EV Steps] in the [CUSTOM1 MENU] menu.
h
Using the rear dial
( )
, adjust the
compensating fl ash output in the Fn menu >
[FLASH].
● blinks in the viewfi nder when the fl ash pops up during Flash
Compensation.
● Compensating fl ash output is not available while using the (Auto mode).
● If the maximum fl ash output is exceeded when corrected to the plus (+)
side, no compensation will be effective.
● Compensating to the minus (-) side may not effect the image if the subject
is too close, aperture is low or sensitivity is high.
Using the Built-in Flash
Flash Characteristics in Each Exposure Mode
■ Using the Flash in Tv (Shutter Priority) Mode
- When taking a moving subject, you can use the fl ash to change the blur
effect.
- Within the shutter speed limit of “1/180” sec or slower, you can use the built-in
fl ash for shooting.
- The aperture value automatically changes according to the ambient
brightness.
■ Using the Flash in Av (Aperture Priority) Mode
- You can set the desired aperture to take a fl ash photograph when you want
to change the depth of fi eld or shoot a subject farther away.
- The shutter speed automatically changes with the ambient brightness.
- The shutter speed shifts automatically anywhere from 1/180 sec. to a slow
shutter speed that reduces camera shake. The slowest shutter speed
depends on the focal length of the lens in use.
Fill-In + Red-eye
FLASH
: Set