Filter
Top Products
091
Changing the Exposure and Shooting (Auto Bracket)
● When the focus mode is set to SAF (Single mode), the focus is locked in
the fi rst frame position and used for subsequent consecutive frames.
● The auto bracketing exposure setting will remain effective for twice as long
as the exposure metering timer (default setting is 20 seconds) when you
release your fi nger from the shutter release button during auto bracketing,
and you can take the next picture at the next compensation value. In this
case, auto focusing works for each frame. After about twice as much time
as the exposure metering timer (default setting is 20 seconds), the camera
returns to settings for taking the fi rst picture.
● You can combine Auto Bracket with the built-in fl ash or external fl ash
(P-TTL auto only) to change only the fl ash output continuously. However,
when using an external fl ash, holding the shutter release button down to
take three continuous frames may cause the second and third frame to be
taken before the fl ash is fully recharged. Always take one frame at a time
after confi rming that charging is complete.
● Auto Bracket is not available when the exposure mode is set to
(Auto
mode) and B(Bulb) mode.
Taking Only Over Exposed or Under Exposed Pictures are Possible by
Using the Auto Bracket Function.
With the previously compensated set of the exposure value, you can have the under
exposure or over exposure shots only.