Filter
Top Products
English _51
● SETUP SCREEN
Sens-up limit : Set the work condition to Auto mode in a low contrast scene.
Lens : You can set the camera lens to AUTO or MANUAL to your preference.
DC(Auto) : Select this if you use the DC lens. Only the iris is adjusted
automatically, but the focus is not controlled automatically.
Manual : Select this if you use a lens on which you adjust the iris and focus
manually.
AGC mode : Specify the level according to the screen luminance.
Indoor/Outdoor : Select Indoor or Outdoor for the installation environment.
Special Setup
Select <Special>.
Select each item and set it properly.
Day & night : You can switch the
mode to adjust the black and white
level as well as the colors.
Color : Always displays the video in
colors.
B/W : Always displays the video in
black and white.
Auto : Displays in color mode during normal daytime and switches to black and
white mode in a low contrast scene at night.
If you set the AGC mode to OFF from <Exposure>, the AUTO DAY/NIGHT mode will be disabled
accordingly.
Externel B/W : Control the image modes of Color and B/W when an external IR
is synchronized via the Alarm In port.
Dwell time : This is the time while each applicable lighting condition is kept in
order to enable the switch between day and night modes.
Duration : Adjust the brightness of the lighting where the mode switch occurs.
Sharpness mode : Adjust the overall sharpness of the image.
If selecting <On>, you can adjust the sharpness of the image.
Sharpness level : The higher the level is, the sharper and clearer the outline of the
image becomes.
Gamma : Adjust the contrast of the image.
Color level : Adjust the color level of the image.
Alarm in : Set the image to Color or B/W depending on the state of the alarm
sensor in sync with the IR.
If the Day & Night mode is set to Externel B/W, the alarm-in function of the event-alarm input page
will be disabled.
•
•
-
-
•
•
1.
2.
•
-
-
-
-
•
•
•
•
•
•
•