Filter
Top Products
setup screen
64_ setup screen
Specify an operation that will perform if an alarm occurs.
Alarm output : Select whether to set the alarm output if an alarm is incoming, and
specify the alarm output time.
E-mail sending : Specify the use of email transfer in the alarm input setup.
FTP sending : Specify the use of FTP transfer in the alarm input setup.
Record : Specify the use of recording in the alarm input setup.
Goto Preset : Moves to the specified preset location when setting the alarm input.
Only if the camera pan/tilt receiver is installed, GoTo Preset is available.
When done, click [Apply (
)].
Motion detection
From the Setup menu, select the
<Event ( )> tab.
Click <Motion detection>.
To set the Motion Detection
Specify the use of motion detection.
Select a sensitivity level of the motion
detection.
Place the cursor at a point in the video
and drag it to whatever you need.
You can specify up to 4 motion detection
areas.
Specify the activation time and
activation condition.
For more information about <Activation
time> and <Action>, refer to “Alarm input”.
(page 63)
When done, click [Apply (
)].
5.
•
•
•
•
•
6.
1.
2.
1.
2.
3.
4.
5.