Filter
Top Products
setup screen
54_ setup screen
To add a preset
Select the preset number to add.
Set the name for the preset.
Press the [
] button.
To delete a preset
Select the preset number to delete.
Press the [ ] button.
To move a preset
Select a preset number that you want to move.
Press the [ ] button.
Specify the serial port.
You can set the RS-485 communication mode for pan/tilt-compliant receiver that is
connected to the network camera.
Protocol : Select one from SAMSUNG-T/ SAMSUNG-E / PELCO-D/ PELCO-P/
SUNGJIN.
Camera ID : Provide a camera ID.
Baud rate : Transfer rate for RS-485 communications
Data : Specify the data bit.
Parity : Specify the parity bit.
Stop bit : Specify the stop bit.
All these operations above mentioned will be enabled only if the network camera is properly
connected to the pan/tilt-compliant receiver. And the serial port for the pan/tilt operations should
be properly specified.
The baud rate may not be controlled depending on the product specifications.
When done, click [Apply
( )
].
1)
2)
3)
1)
2)
1)
2)
6.
•
•
•
•
•
•
M
J
7.