Filter
Top Products
Camera Settings (CAMERA)
20
3
Use the joystick lever (xy) to select [BURST] and
use the lever (vw) to select “ON/OFF”.
If the camera is connected to peripheral devices like frame
switcher, burst may occur when the viewing mode is switched
between the color mode and the black and white mode. In this
case, compensate for the image by inserting the color burst
signals.
In general, set this option to “OFF”.
Available settings:
•ON: The color burst signal is turned on.
•OFF: The color burst signal is turned off.
4
Use the joystick lever (xy) to select [FOCUS] and
use the lever (vw) to select the focus compensation
mode.
In general, set this option to “2”. If images are out of focus, set
this option to “1”.
Available settings:
•1: Near-infrared wavelength correction (around 900nm) is
set during the black and white mode.
•2: Visible light spectrum is set during the color mode.
☞ After completing setting, use the lever to move the cursor to
[MENU] and select “BACK” or “END”.
b Using the color mode only (COLOR)
Regardless of the luminance level, only use the color mode to view
the image.
1
Use the joystick lever (xy) to select [DAY/NIGHT],
use the lever (vw) to select “COLOR y”, and press
the [ENTER] button.
The D/N SETTING-COLOR screen appears.
2
Use the joystick lever (xy) to select [EXT ALARM]
and use the lever (vw) to select the channel used
for external alarm input.
When [EXT ALARM] is set to “1” - “8”, receiving external alarm
input automatically switches the color mode to the black and
white mode.
Available settings:
•OFF: Does not switch the color mode to the black and
white mode when receiving external alarm input.
•1- 8: Switches the color mode to the black and white
mode when receiving external alarm input.
(Select an input channel used for external alarm
input.)
☞ After completing setting, use the lever to move the cursor to
[MENU] and select “BACK” or “END”.
While the Day/Night function is set to “AUTO”, the
following applies.
• Multi-spot evaluative metering (MULT) selected in the
backlight compensation level (BLC) setting works
during the color mode.
• The electronic sensitivity boosting (SENSE UP)
selected in the lens aperture (IRIS) setting works
during the black and white mode.
• The AGC function cannot be set to “OFF”.
D/N SETTING-COLOR
EXT ALARM
PRESET
MENU
OFF
OFF
BACK