Sanyo VCC-MC700P Security Camera User Manual


 
Alarm Settings (ALARM)
41
The Alarm Disable function allows the alarm input to be ignored
for the specified duration during manual pan/tilt/zoom
operations and after manual operation.
Memo: You can also turn on or off the ALARM DISABLE function by
using the system controller. Press the [AUX ON] or [AUX
OFF] button, and select "8" in the number entry screen.
1
Use the joystick lever (xy) to select [ALARM
DISABLE], use the lever (vw) to select “ON/OFF”,
and press the [ENTER] button.
Available settings:
•OFF: Disables the Alarm Disable function.
•ON: Enables the Alarm Disable function. ([TIME] appears
under [ALARM DISABLE].)
2
When “ON” is selected, use the joystick lever (xy)
to select [TIME] and use the lever (vw) to select a
duration for which the alarm input is ignored.
Available settings: 1M, 2M, 3M, 4M, 5M, 6M, 7M, 8M, 9M,
10M (M: Minute)
After completing setting, use the lever to move the cursor to
[MENU] and select “BACK” or “END”.
The built-in motion sensor can be used to detect movements in
the target object such as an intruder.
Use the joystick lever (xy) to select [MOTION] and use
the lever (vw) to select the motion sensor used for alarm
detection.
Available settings:
•OFF: Does not use the motion sensor.
•ZONE: Uses the sensor specified for the motion zone. (The
MOTION ZONE screen appears.)
•PRESET: Uses the motion sensor selected in [MOTION] of the
[CAMERA VIEW] settings.
Memo: For the “PRESET” option, the movement is detected only at
the preset position: for the [ZONE] option, the movement is
detected for the area specified from whole space where
pan/tilt operations can be performed.
b Setting the motion zone
The Motion Zone function allows you to specify up to four surveillance
areas (AREA 1 - 4) to detect movement.
To set the surveillance area and the detection option, perform the
following procedure in the MOTION ZONE screen.
1
Use the joystick lever (xy) to select [MOTION], use
the lever (vw) to select “ZONE”, and press the
[ENTER] button.
The MOTION ZONE screen appears.
2
Use the joystick lever (xy) to select [AREA (1 - 4)],
use the lever (vw) to select “ON y”, and press the
[ENTER] button.
The AREA setting menu appears.
C
Setting the alarm disabling duration
(ALARM DISABLE)
ALARM
y
y
ALARM DISABLE
TIME
ALARM IN
ALARM OUT
MOTION
ALARM DISPLAY
PRESET
MENU
1
1
ON
2M
OFF
OFF
OFF
BACK
D Setting the motion sensor (MOTION)
Setting the surveillance area (AREA) and the detection
option
ALARM
y
y
ALARM IN
ALARM OUT
ALARM DISABLE
MOTION
ALARM DISPLAY
PRESET
MENU
1
1
OFF
OFF
OFF
OFF
BACK
MOTION ZONE
AREA 1
AREA 2
AREA 3
AREA 4
SENSITIVITY y
ALARM OUT
LINE OUT
DURATION
OFF
OFF
OFF
OFF
SET
OFF
OFF
5S
AREA 1
POSITION y
DISPLAY
SET
OFF