Filter
Top Products
Miscellaneous Settings (OPTION)
51
When the motion sensor detects a movement of the target
object, the orientation of the camera automatically changes
pursuing the target object.
Memo: You can also turn on or off the AUTO PURSUIT function by
using the system controller. Press the [AUX ON] or [AUX
OFF] button, and select "9" in the number entry screen.
1
Use the joystick lever (xy) to select [AUTO
PURSUIT] and use the lever (vw) to select “ON y”,
and press the [ENTER] button.
The AUTO PURSUIT screen appears.
If you do not enable the auto pursuit function, set [AUTO
PURSUIT] in the OPTION screen to "OFF".
2
Use the joystick lever (xy) to select [SENSITIVITY],
and use the lever (vw) to set the sensitivity for
movement detection.
The higher the setting value, the lower the sensitivity.
3
If you want to test the sensitivity, use the joystick
lever (xy) to select [TEST], and use the lever (vw) to
select [ON].
When a movement is detected, a sensor pattern appears at
the detected position. Adjust the setting value as necessary.
☞ After completing setting, use the lever to move the cursor to
[MENU] and select “BACK” or “END”.
Reverses the displayed image electronically. This function can
be used when the camera is installed upside down or when
performing surveillance through a mirror.
1
Use the joystick lever (xy) to select [MIRROR] and
use the lever (vw) to select a mirroring mode.
Available settings:
•OFF: Normal image
•HV: Rotated horizontally and vertically.
•H: Rotated horizontally.
•V: Rotated vertically.
Memo: The “HV” option can be used when the camera is installed on
the floor. In this option, the direction to which the joystick
lever is moved matches the direction to which the camera
pans and tilts.
☞ After completing setting, use the lever to move the cursor to
[MENU] and select “BACK” or “END”.
Cleans the camera’s horizontal rotation contact area.
1
Use the joystick lever (xy) to select [REFRESH] –
“SET y”, and press the [ENTER] button.
Cleaning starts, and after the cleaning completes the startup
movements are performed.
Memo: The horizontal rotation contact area of the camera always
moves. When the contact area becomes dirty, the camera’s
operation can be unstable, burst can occur, or preset
positions may deviate. It is recommended to clean the
rotation contact area periodically by using the Refresh
function.
☞ After completing setting, use the lever to move the cursor to
[MENU] and select “BACK” or “END”.
D
Setting the auto pursuit function
(AUTO PURSUIT)
This function cannot be configured when [MOTION] in
the ALARM screen is set to "PRESET" or "ZONE".
• The motion sensor detects the movement of the target
object by perceiving the change of the brightness.
The pursuit function may not work depending on the
condition including the size or brightness of the
target object.
• When there are multiple target objects that are
moving, the camera pursues the target object whose
change of the brightness is larger.
• The auto pursuit function is not activated while
panning, tilting or zooming function is in operation, or
AUTO MODE or PRESET GO mode is selected.
OPTION
INFORMATION
AUTO FLIP
STABILIZER
AUTO PURSUIT
MIRROR
REFRESH
y
y
y
SET
OFF
OFF
ON
OFF
SET
7
TEST
OFF
AUTO PURSUIT
[SENSITIVITY]
E
Setting the mirroring function
(MIRROR)
F
Performing the refresh function
(REFRESH)
OPTION
INFORMATION
AUTO FLIP
STABILIZER
AUTO PURSUIT
MIRROR
REFRESH
y
y
SET
ON
OFF
OFF
OFF
SET
OFF HV H V
OPTION
INFORMATION
AUTO FLIP
STABILIZER
AUTO PURSUIT
MIRROR
REFRESH
y
y
SET
ON
OFF
OFF
OFF
SET