Filter
Top Products
Miscellaneous Settings (OPTION)
50
Rotates the displayed image up or down, left or right
electronically when the camera tilts beyond the straight down
position.
1
Use the joystick lever (xy) to select [AUTO FLIP]
and use the lever (vw) to select “ON”.
Available settings:
•OFF: Disables the Auto Flip function. (When the tilting
angle reaches 90 degrees, the camera stops.)
•ON: Enables the Auto Flip function, allowing you to
continue monitoring when the camera is tilted
beyond the straight down position.
The image is rotated automatically to change inverse image to
normal image.
☞ After completing setting, use the lever to move the cursor to
[MENU] and select “BACK” or “END”.
When the base on which the camera is installed (e.g. column,
pole or wall) sways, the image from the camera is corrected
automatically.
1
Use the joystick lever (xy) to select [STABILIZER]
and use the lever (vw) to select “ON y”, and press
the [ENTER] button.
The STABILIZER screen appears.
Set [STABILIZER] to "OFF" in the OPTION screen when the
correction of the sway is not required.
2
Use the joystick lever (vw) to select the correction
level.
The higher the collection level, the more the amount of
correction, covering the large sway.
Available settings:
•LOW:
• MIDDLE:
•HIGH:
☞ After completing setting, use the lever to move the cursor to
[MENU] and select “BACK” or “END”.
B
Setting the auto flip function
(AUTO FLIP)
An image is rotated upside down electronically when the
tilting angle reaches around 90 degrees.
(When the Auto Flip takes place, the tilting motion
momentarily stops.)
OPTION
INFORMATION
AUTO FLIP
STABILIZER
AUTO PURSUIT
MIRROR
REFRESH
y
y
PRESET
MENU
SET
ON
OFF
OFF
OFF
SET
OFF
BACK
0 degrees
90 degrees
180 degrees
Normal image
Normal image
ON: Inverse image
Inverse image → Normal image
C
Correcting the sway of the camera
(STABILIZER)
• The waver correction function may not work
depending on the magnitude of waver and/or its
frequency.
• The waver correction function does not work while the
camera is in motion during such operation or mode as
panning, tilting, zooming, automatic panning (AUTO
MODE) or moving to a preset position (PRESET GO).
However, the waver correction is available when the
camera is in resting state, even if any of these
functions or modes is selected.
• While the waver is being corrected, the resolution of
the image degrades and the angle of the image
narrows a bit. The higher the correction level, the
lower the resolution, and the narrower the angle.
OPTION
INFORMATION
AUTO FLIP
STABILIZER
AUTO PURSUIT
MIRROR
REFRESH
y
y
y
PRESET
MENU
SET
OFF
ON
OFF
OFF
SET
OFF
BACK
STABILIZER
LEVEL
PRESET
MENU
MIDDLE
OFF
BACK