Filter
Top Products
Alarm Settings
B Detecting Intruders Using Motion
Detector Settings
You can set sensor marks in the live image
screen to detect intruders.
When an alarm is detected, an alarm buzzer can
be made to sound and the ALARM indicator on
the live image screen can be made to illuminate.
1
Set “ALARM REC USE” to “NO USE”
(example), and then click the [SET] button.
Set to “NO USE” first so that alarms cannot
be detected while you are making the
settings. Change the setting back to “USE”
after you have finished making the settings.
2
Set “EXTERNAL ALARM” to “OFF”
(example).
3
Set “MOTION DETECTOR” to “ON”.
The motion detector level and MOTION
DETECTOR SET screen will be displayed.
Available settings:
•
OFF: Motion detector operation is not
carried out.
•
ON: The MOTION DETECTOR SET
screen is displayed.
4
Use the drop-down list box to change the
“MOTION DETECTOR LEVEL” setting
(example: “2”).
The smaller the value selected, the higher
the sensitivity.
Available settings: 1 to 10 (default setting: 5)
5
Set the sensor marks.
These correspond to the live image screen
and the sensing area.
•
Move the pointer to the same position (grid area)
as the area of the live image screen that you
would like sensing to be carried out, and then
click the mouse button.
A sensor mark (ú) will be displayed. Click in the
same place once more to clear the mark.
•
In the same way, insert sensor marks in other
places as required.
After setting the sensor marks, the sensor
sensitivity can be adjusted. (p. 41)
6
Set “ALARM OUT” to “NO” (example).
Available settings:
•
OFF: No alarm is output when an alarm is
received.
•
NC: Normal close (normally closed, but
an alarm is output when open).
•
NO: Normal open (normally open, but an
alarm is output when closed).
Note: If “ALARM OUT” has been set to “NO”
or “NC” for the COLOR mode or
TIMER mode DAY/NIGHT settings
and an IR lamp has been connected,
then the buzzer will not sound. (p. 32,
34)
7
Set “ALARM OUT MODE” to “ALARM
OUT”.
8
Use the drop-down list box to change the
“ALARM OUT TIME” setting to “60 sec.”
(example).
Available settings:
2, 5, 10, 15, 20, 30, 60 sec.,
2, 3, 4, 5 min., REMOTE
(The “REMOTE” setting only appears
when “ALARM OUT MODE” is set to
“REMOTE CONTROL”.)
1
2
3
4
5
6
7
8
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
– 40 –
English