Filter
Top Products
Recording and Deleting Alarm Images
Setting E-mail Message
Transmissions
1
Click the [DETAIL] button next to “ALARM
NOTICE (SMTP) SET”.
The ALARM NOTICE (SMTP) SET screen
will be displayed.
2
Enter the SMTP server address and the
user’s e-mail address.
3
Enter the recipient’s e-mail address.
4
Select the check boxes for the recipient
e-mail addresses.
These check boxes let you select whether
e-mail messages are to be sent to an
address or not.
5
Select the “ATTACH IMAGE” check boxes.
These check boxes let you select whether
image attachments are to be sent to an
address or not.
6
Enter the e-mail subject and the message
text.
The e-mail subject can be up to 32
single-byte characters (16 double-byte
characters).
The message text can be up to 64
single-byte characters (32 double-byte
characters).
7
Set the authentication to “POP3”
(example), and then enter the POP3 server
address, user ID and password.
This sets the POP3 server settings and
whether user authentication is carried out or
not before e-mail messages are sent.
“USER ID” and “PASSWORD” must be
entered for user authentication to be carried
out.
You must enter the POP3 server address if
using a POP3 server.
8
Click the [TEST] button to send a test
e-mail message.
9
Check the log display, and if there are no
problems, click the [SET] button.
This completes the settings. When an alarm
is detected, an image and a message will be
sent to the specified e-mail addresses.
Note: Be sure to make the required DNS server
settings in the network settings (p. 20). If
these settings have not been made, it will
not be possible to use the e-mail
addresses that are entered afterwards.
Check with your network administrator for
details.
2
5
3
4
6
7
8
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
– 50 –
English