Filter
Top Products
Alarm Settings
B Continuous Alarm Output
1
Set “ALARM REC USE” to “NO USE” and
then click the [SET] button.
Set to “NO USE” first so that alarms cannot
be detected while you are making the
settings. Change the setting back to “USE”
after you have finished making the settings.
2
Set “ALARM OUT” to “NO” (example).
Available settings:
•
OFF: No alarm is output when an alarm is
received.
•
NC: Normal close (normally closed, but
an alarm is output when open).
•
NO: Normal open (normally open, but an
alarm is output when closed).
3
Set “ALARM OUT MODE” to “REMOTE
CONTROL”.
Available settings:
•
REMOTE CONTROL: Remote alarm
operation is carried out. The REMOTE
ALARM indicator will appear at the top of
the live image screen.
•
ALARM OUT: Remote alarm operation is
not carried out.
4
Set “ALARM OUT TIME” to “REMOTE”.
Available settings:
2, 5, 10, 15, 20, 30, 60 sec.,
2, 3, 4, 5 min., REMOTE
(The “REMOTE” setting only appears
when “ALARM OUT MODE” is set to
“REMOTE CONTROL”.)
5
Change the “ALARM REC USE” setting
that was set in step 1 back to “USE”, and
then click the [SET] button.
This completes the setting, so return to the
live image screen. The REMOTE ALARM
indicator (gray) will be displayed in the initial
screen.
6
While monitoring the live images, click the
“REMOTE ALARM” indicator.
The REMOTE ALARM indicator will
illuminate orange and alarms will be output
continuously. The alarm output will be
toggled on and off each time you click the
indicator.
2
3
4
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
– 44 –
English