Filter
Top Products
Recording and Deleting Alarm Images
1
SMTP SERVER ADDRESS
Enter the SMTP server address.
2
USER MAIL ADDRESS
Enter the e-mail address for the sender of the
e-mail messages.
3
RECIPIENT MAIL ADDRESS
Enter the e-mail addresses for the recipients
of the e-mail addresses. Up to a maximum of
5 e-mail addresses can be entered.
Note: The addresses in 1 to 3 can consist of only
single-byte characters. Up to a maximum of
64 characters can be entered for each
address.
4
SUBJECT
Enter the subject for the e-mail messages.
Up to a maximum of 32 single-byte
characters can be entered.
5
TEXT
Enter the message text for the e-mail
messages.
The body of the e-mail messages consists of the
camera title, date and time, camera IP address
and the message text (variable). The part that
you can enter here is the message text.
The other parts of the message body are
generated and sent automatically. The
message text can consist of up to 64
single-byte characters.
The basic contents of an e-mail message are:
•
Camera title:
The title of the camera that detected the alarm.
•
Date and time:
The date and time that the alarm was detected.
•
IP address:
The IP address of the camera that detected the
alarm.
•
Message text:
The message that you would like to add to
e-mail messages.
6
AUTHENTICATION
This sets how the user authenticates the
e-mail messages before they are transmitted.
It can be set to POP before SMTP or SMTP
authentication.
Available settings:
NO USE, POP3 (POP
before SMTP), SMTP
(SMTP authentication)
Note:
•
SMTP authentication conforms to the following
two formats:
•
CRAM-MD5
•
LOGIN
•
If authentication is to be carried out, you will
need to check with the Internet provider whether
setting of authentication is available. Check the
authentication environment used by the provider
being connected to before making this setting.
7
POP3 SERVER ADDRESS
Enter the POP3 server address. Up to a
maximum of 64 single-byte characters can be
entered. This must be entered if you would
like to use POP before SMTP user
authentication.
8
USER ID
Enter the user ID for the sender of the e-mail
messages (such as an Administrator). Up to
a maximum of 48 single-byte characters can
be entered. This must be entered if you
would like to use user authentication.
9
PASSWORD
Enter a password for the sender of the e-mail
messages (such as an Administrator). Up to
a maximum of 20 single-byte characters can
be entered. This must be entered if you
would like to use user authentication.
F
LOG
This shows the e-mail transmission status.
Error and transmission completed messages
are displayed server messages.
G
[TEST] button
This button is used for test transmissions.
After you have entered all of the required
information, you can click this button to send
a test message. The images that are sent
with test messages are live images.
Note: The settings from 1 to 9 are settings that
are related to the sending and receiving of
e-mail messages. The way that they are
entered will vary depending on the Internet
provider and the network environment being
used. Check with your Internet provider and
network administrator for details.
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
English
– 49 –