Filter
Top Products
Recording and Deleting Alarm Images
A Recording Post-alarm Images
Only
1
Set detection of intruders using
“A Detecting Intruders Using an External
Sensor” (or “B Detecting Intruders Using
Motion Detector Settings”). (p. 38, 40)
Set either external alarm sensor or motion
detector detection, and then click the
[DETAIL] button for “ALARM BUFFERING”.
The ALARM BUFFERING SET screen will be
displayed. (p. 45)
2
Set “BUFFERING AREA (PRE/POST)” to
“0%/100%”.
When an alarm is detected, the ratio will be
set to PRE = 0% (zero)/POST = 100%. In
other words, only post-alarm recording will be
set.
3
If an alarm is detected in the live image
screen, the indicators will illuminate as
follows and the images will be recorded
into the internal memory.
(1) Alarm not detected (all indicators are
off)
(2) An alarm is detected and alarm data is
recorded automatically into the
internal memory
(3) Recording of alarm data into the
internal memory is complete
Once this happens, the recorded data can
then be played back.
Note: The alarm data that has been recorded
into the internal memory is recorded at the
PRIORITY and ALARM RESOLUTION
that have been set in the ALARM
BUFFERING SET screen. If high quality
and a large image size have been set, it
will take longer for the images to be
refreshed.
B Recording Both Pre-alarm and
Post-alarm Images
When an alarm is detected, recording is
assigned between the pre- and post-alarm
recording areas in the ratio specified. You can
increase or decrease the length of time that
images are recorded before an alarm is detected.
1
Set detection of intruders using
“A Detecting Intruders Using an External
Sensor” (or “B Detecting Intruders Using
Motion Detector Settings”). (p. 38, 40)
Set either external alarm sensor or motion
detector detection, and then click the
[DETAIL] button for “ALARM BUFFERING”.
The ALARM BUFFERING SET screen will be
displayed. (p. 45)
2
Set “BUFFERING AREA (PRE/POST)” to
“20%/80%”.
3
If an alarm is detected in the live image
screen, the indicators will illuminate as
follows and the images will be recorded
into the internal memory.
(1) Pre-alarm recording starts
automatically
Images are recorded in the pre-alarm
recording area (PRE 20%).
(2) Alarm detected
Alarm data is automatically recorded into the
post-alarm recording area (POST 80%).
(Red) (Orange)
(Red or green)
(Orange)
(Red) (Orange)
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
– 46 –
English