Filter
Top Products
Recording and Deleting Alarm Images
Saving into the Camera’s Internal
Memory
If you click the [DETAIL] button next to “ALARM BUFFERING”, the ALARM BUFFERING SET screen
will be displayed.
This screen is used to set the way in which the alarm data that is generated when an alarm is detected
is recorded into the camera’s internal memory. The recording capacity of the internal memory is set to a
default of approximately 16 MB per alarm event.
1
ALARM DATA SIZE
This sets the size for alarm data that is recorded
into the internal memory. The pre/post selection
ratio for the alarm recording area will vary
depending on the size that is set.
Available settings:
•
16, 12, 8, 4 MB: All available alarm recording
area ratios can be selected.
•
2 MB: The pre/post ratio of 10%/90% cannot
be selected.
•
1 MB: The pre/post ratios of 10%/90% and
20%/80% cannot be selected.
•
0.5 MB, TWO IMAGES: The pre/post ratio is
fixed at 0%/100%.
Note: “TWO IMAGES” can be selected when
PPP is being used.
2
BUFFERING AREA (PRE/POST)
This sets the ratio between the pre-alarm and
post-alarm recording areas in the internal
memory.
Available settings:
0%/100%, 10%/90%, 20%/80%, 30%/70%,
40%/60%, 50%/50%
3
BUFFERING RATE
This sets the recording rate (buffering rate) when
data is being recorded into the internal memory.
Available settings:
MAX, 10FPS, 5FPS, 2FPS, 1FPS
4
PRIORITY
This sets the quality for the images recorded in
the internal memory.
•
PICTURE QUALITY: Alarm images are
recorded at high image quality.
•
RECORDING RATE: Images are recorded
with speed as the priority.
5
ALARM RESOLUTION
This sets the image size for data being recorded
into the internal memory.
When playing back images that have been
recorded at a size of 720x240, the vertical size
will be adjusted so that they become 720x480
images.
Available settings: 160x120, 320x240,
640x480, 720x240, 720x480
6
OVERWRITE (only displayed when using
an expansion memory card)
Always be sure to insert the expansion memory
card into the card slot before turning on the
power for the camera. If you insert the card after
the power has been turned on, this item will not
be displayed.
If this is set to “ON”, old alarm images are
automatically deleted when the internal memory
becomes full, and the new data is written over as
it is captured.
Note: Refer to “Glossary of Terms” for details
on pre-alarm and post-alarm recording.
(p. 72)
1
2
3
4
5
6
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
English
– 45 –