Filter
Top Products
Putting the devices into operation
11
Mounting the diversity receiver to a camera
Use the supplied CA 2 camera adapter to mount the receiver to a camera’s flash mount.
̈ Determine where on the perforated plate ƹ the flash mount adapter ƺ will need to be
fastened so that the receiver can best be attached to the camera.
̈ At this position, place a square nut ƻ under the perforated plate ƹ.
̈ Fasten the flash mount adapter ƺ to the perforated plate ƹ using the square nut ƻ.
̈ Lift one side of the belt clip Ƽ as shown.
̈ Press down the belt clip Ƽ at one fixing point and pull it out of the receiver housing.
̈ Repeat for the other side.
̈ Place the perforated plate ƹ onto the rear of the receiver.
̈ Reinsert the belt clip Ƽ.
̈ Use one of the supplied line cables to connect the line input of the camera to the
socket ³.
ƹ
ƺ
ƻ
The shield of the line cable serves as the antenna for the second diversity section.
Ƽ
³
ew 100 P G3 Set _529660_0309_Sp9.book Seite 11 Mittwoch, 8. April 2009 6:57 18