Filter
Top Products
If a problem occurs ...
30
SK 100/SKM 100/SKP 100 G3
If a problem occurs that is not listed in the above table or if the problem cannot be solved with the proposed solutions,
please contact your local Sennheiser partner for assistance. To find a Sennheiser partner in your country, search at
www.sennheiser.com under “Service & Support”.
Problem Possible cause Possible solution
Transmitter cannot be
operated, “Locked”
appears on the display
panel
Lock mode is activated Deactivate the lock mode (see page 20).
No operation indication Batteries are flat or accupack is flat Replace the batteries or recharge the accupack
(see page 13).
No RF signal at the
receiver
Transmitter and receiver are not on the
same channel
Synchronize the transmitter with the receiver
(see page 19).
Set the transmitter to the same channel as the
receiver.
Transmission range is exceeded Reduce the distance between receiver and
transmitter.
RF signal is deactivated (“RF Mute“) Activate the RF signal (see page 21).
RF signal available,
no audio signal,
“MUTE” appears on the
display panel
Transmitter is muted (MUTE) Cancel the muting (see page21).
Receiver’s squelch threshold is adjusted
too high
Reduce the squelch threshold setting on the
receiver.
Transmitter doesn’t transmit a pilot tone Activate or deactivate the pilot tone transmis-
sion (see page 25).
Audio signal has a high
level of background noise
or is distorted
Transmitter’s sensitivity is adjusted too
low/too high
Adjust the input sensitivity (see page 25).
ew 100 P G3 Set _529660_0309_Sp9.book Seite 30 Mittwoch, 8. April 2009 6:57 18