Filter
Top Products
Using the devices
16
Plugging the plug-on transmitter onto a microphone
̈ Plug the microphone’s XLR-3M socket onto the transmitter’s XLR-3F socket ³.
̈ Tighten the locking ring · in the direction of the arrow.
Using the devices
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on.
2. Switch a transmitter on.
The transmission link is established and the diversity receiver’s RF level display “RF”
reacts.
If you cannot establish a transmission link between transmitter and diversity receiver:
̈ Make sure that transmitter and diversity receiver are set to the same frequency bank and
to the same channel.
̈ If necessary, read the chapter “If a problem occurs ...” on page29.
The transmitter uses the microphone body as an antenna – therefore microphones
with a metal casing should be used for best signal transmission.
It is vital to observe the following notes:
̈ Make sure that the desired frequencies are listed in the enclosed frequency
information sheet.
̈ Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
·
³
ew 100 P G3 Set _529660_0309_Sp9.book Seite 16 Mittwoch, 8. April 2009 6:57 18