Filter
Top Products
Putting the devices into operation
12
SK 100 G3 bodypack transmitter
Inserting the batteries/accupack/Charging the accupack
The procedure is the same as for the EK 100 G3 diversity receiver:
To insert the batteries/accupack:
̈ Read the chapter “Inserting the batteries/accupack” on page 10.
To charge the accupack:
̈ Read the chapter “Charging the accupack” on page10.
Connecting the microphone cable/line cable
The audio input is designed for the connection of condenser microphones. DC powering of the
condenser microphones is via the audio input MIC/LINE³ (3.5 mm jack socket).
̈ Use one of the recommended Sennheiser microphones or the optional CL 2 line cable.
̈ Connect the 3.5 mm jack plug ƺ from the Sennheiser cable to the 3.5 mm jack socket
MIC/LINE ³.
̈ Lock the 3.5 mm jack plug by screwing down the coupling ring ƻ of the cable.
̈ Via the operating menu, adjust the sensitivity of the microphone/line input.
Attaching and positioning the corresponding microphones
ME 2/ME 4
̈ Use the microphone clip Ƽ to attach the microphone to clothing (e.g. tie, lapel).
The ME 2 clip-on microphone (shown on the right in the diagram) has an omni-directional
pick-up pattern. It is therefore not necessary to position it precisely.
̈ Attach the ME 2 microphone as close as possible to the sound source.
The ME 4 clip-on microphone (shown on the left in the diagram) has a cardioid pick-up
pattern.
̈ Position the ME 4 microphone so that its sound inlet is directed towards the sound source
(e.g. mouth).
³
ƻ
ƺ
Ƽ
ew 100 P G3 Set _529660_0309_Sp9.book Seite 12 Mittwoch, 8. April 2009 6:57 18