Filter
Top Products
If a problem occurs ...
29
If a problem occurs ...
EK 100 G3
Problem Possible cause Possible solution
Diversity receiver cannot
be operated, “Locked”
appears on the display
panel
Lock mode is activated Deactivate the lock mode (see page 20).
No operation indication Batteries are flat or accupack is flat Replace the batteries or recharge the accupack
(see page 10).
No RF signal Transmitter and receiver are not on the
same channel
Set the transmitter and receiver to the same
channel.
Synchronize the transmitter with the receiver
(see page 19).
Transmission range is exceeded Reduce the distance between receiver and
transmitter.
RF signal is deactivated (“RF Mute“) Activate the RF signal (see page 21).
RF signal available, no
audio signal, “MUTE”
appears on the display
panel
Transmitter is muted Cancel the muting (see page 21).
Receiver’s squelch threshold is adjusted
too high
Reduce the squelch threshold setting on the
receiver (see page24).
Transmitter doesn’t transmit a pilot tone Deactivate the pilot tone evaluation
(see page 24).
Audio signal has a high
level of background noise
Transmitter sensitivity is adjusted too
low
Adjust the transmitter sensitivity correctly
(“Sensitivity”, see page 25).
Audio signal is distorted Transmitter sensitivity is adjusted too
high
Adjust the transmitter sensitivity correctly
(“Sensitivity”, see page 25).
Receiver’s audio output level is adjusted
too high
Reduce the audio output level (“AF Out”, see
page 24).
No access to a certain
channel
During scanning, an RF signal has been
detected on this channel and the channel
has been locked
Set the transmitter operating on this channel to
a different channel and redo the frequency
preset scan (see page 24).
During scanning, a transmitter of your
system operating on this channel has not
been switched off
Switch the transmitter off and redo the
frequency preset scan (see page 24).
ew 100 P G3 Set _529660_0309_Sp9.book Seite 29 Mittwoch, 8. April 2009 6:57 18