Filter
Top Products
Putting the devices into operation
13
Attaching the bodypack transmitter to clothing
You can use the belt clip ƽ to attach the bodypack transmitter to clothing (e.g. belt, waist-
band).
The belt clip is detachable so that you can also attach the transmitter with the antenna
pointing downwards. To do so, withdraw the belt clip ƽ from its fixing points and attach it
the other way round. The belt clip ƽ is secured so that it cannot slide out of its fixing points
accidentally.
To detach the belt clip:
̈ Lift one side of the belt clip as shown in the diagram on the right-hand side.
̈ Press down the belt clip at one fixing point and pull it out of the transmitter housing.
̈ Repeat for the other side.
SKM 100 G3 radio microphone
̈ Only hold the radio microphone by its body.
Inserting the batteries/accupack
For powering the radio microphone, you can either use two 1.5 V AA size batteries or the
rechargeable Sennheiser BA 2015 accupack.
̈ Unscrew the lower part of the radio microphone from the radio microphone’s body » by
turning it counterclockwise.
̈ Slide back the lower part of the radio microphone as far as it will go.
̈ Open the battery compartment cover Ƹ (see page 14).
̈ Insert the batteries or the BA 2015 accupack as shown on the battery compartment
cover. Observe correct polarity when inserting the batteries/accupack (see page 14).
ƽ
If you touch the antenna of the radio microphone during operation, the trans-
mitter’s range will be considerably reduced!
»
When unscrewing the radio microphone during operation, the muting function is
automatically activated. “MUTE” appears on the display panel.
When screwing the lower part of the radio microphone back to the radio micro-
phone’s body, the muting is canceled.
ew 100 P G3 Set _529660_0309_Sp9.book Seite 13 Mittwoch, 8. April 2009 6:57 18