Filter
Top Products
Using the devices
19
Synchronizing a transmitter with the diversity receiver
You can synchronize a suitable transmitter of the ew 100 G3 series with the diversity
receiver. During synchronization, the following parameters are transferred to the trans-
mitter:
To switch your transmitter on and to deactivate the RF signal on switch-on (offline operation):
SK 100 G3 SKM 100 G3 SKP 100 G3
̈ Keep the ON/OFF
button Ƹ pressed until
“RF Mute On?” appears
on the display panel.
̈ Press the SET button ¶.
̈ Keep the ON/OFF
button ¹ pressed until
“RF Mute On?” appears
on the display panel.
̈ Press the multi-function
switch ¸.
̈ Keep the ON/OFF
button º pressed until
“RF Mute On?” appears
on the display panel.
̈ Press the SET button µ.
The transmission frequency is displayed but the transmitter does not transmit an
RF signal.
The transmission icon ብ is not displayed.
To activate the RF signal:
̈ Briefly press the ON/OFF
button Ƹ.
“RF Mute Off” appears
on the display panel.
̈ Press the SET button ¶.
The transmission iconብ
is displayed again.
̈ Briefly press the ON/OFF
button ¹.
“RF Mute Off” appears
on the display panel.
̈ Press the multi-function
switch ¸.
The transmission icon ብ
is displayed again.
̈ Briefly press the ON/OFF
button º.
“RF Mute Off” appears
on the display panel.
̈ Press the SET button µ.
The transmission icon ብ
is displayed again.
MHz
533.875
ew100 G3
MUTE
P
AF
ብ
MHz
533.875
ew100 G3
MUTE
P
AF
ብ
MHz
533.875
ew100 G3
MUTE
P
AF
ብ
Use this function to save battery power or to prepare a transmitter for use during
live operation without causing interference to existing transmission links.
Setting Transferred parameters
“Frequency Preset” Currently set frequency
“Name” Freely selectable name currently set on the receiver
“Pilot Tone” Current pilot tone setting of the receiver (“Inactive”/“Active”)
ew 100 P G3 Set _529660_0309_Sp9.book Seite 19 Mittwoch, 8. April 2009 6:57 18