Filter
Top Products
23
Advanced Operations
CCD-TR2300/TR3300 3-856-204-23 (1)
CCD-TR3300 for other than Canadian model and CCD-TR2300 only:
(1) Connect the AC power cord to a wall outlet.
(2) Slide the connecting plate down into the guides at the rear of the camcorder
until it clicks.
Charging the battery pack
—CCD-TR3300 for Canadian model only
After connecting the power cord to the house current and setting the POWER switch on
the camcorder to OFF, you can charge the battery pack in either of the following two ways:
(When charging begins, the CHARGE lamp lights.)
• Charging the battery attached to the camcorder
Leave the battery pack attached to the camcorder. (The NP-F530 battery pack requires
about 210 minutes for a full charge and about 150 minutes for a normal charge.)
• Charging two battery packs at the same time
Attach one battery pack to the AC power adaptor and the other to the camcorder. Both
are charged simultaneously. When charged, both lamps go out (normal charge). If
either lamp is still lit, both batteries are not charged (the NP-F530 battery packs require
about 240 minutes for a full charge and about 180 minutes for a normal charge).
You can also charge the battery pack in either of the above two ways by connecting the
AC power adaptor to the Edit Station and setting the POWER switch on the Edit Station
to OFF.
Notes on the VTR/CAMERA lamp
• The VTR/CAMERA lamp will remain lit for a while even if the unit is unplugged
after use. This is normal.
• If the VTR/CAMERA lamp does not light, disconnect the power cord. After about 1
minute, reconnect the power cord.
To remove the connecting plate
Pull out the connecting plate by the plate. Never pull the connecting cord itself.
WARNING
The power cord must only be changed at a qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (house current) as long as it is
connected to the house current, even if the set itself has been turned off.
12