Filter
Top Products
85
Additional information
CCD-TR2300/TR3300 3-856-204-23 (1)
Trouble check
Cause and/or Corrective Action
• The battery pack is not installed.
m Install the battery pack. (p.8)
• The battery is dead.
m Use a charged battery pack. (p.6)
• The AC power adaptor is not connected to a wall outlet.
m Connect the AC power adaptor to a wall outlet. (p.22)
• You use other types of battery except NP-F530/F730.
• While being operated in CAMERA mode, the camcorder has
been in Standby mode for more than 5 minutes.
m Turn STANDBY down once and then up again. (p.11)
• The battery is dead.
m Use a charged battery pack. (p.6)
• If the VF PW-SAVE is set to ON in the menu system, the
picture disappears automatically when you turn your face
away from the viewfinder.
m Bring your face close to the viewfinder within 1/2 inch
(1 cm). Or set VF PW-SAVE to OFF in the menu system.
(p.26)
• The ambient temperature is too low.
• The battery pack has not been charged fully.
m Charge the battery pack again. (p.6)
• The battery pack is completely dead, and cannot be recharged.
m Use another battery pack. (p.8)
• You use other types of battery except NP-F530/F730.
• The battery pack is discharged during a long period of
storage.
m Charge the battery pack again. (p.6)
• The tape is stuck to the drum.
m Eject the tape. (p.9)
• The tape has run out.
m Rewind the tape or use a new one. (p.19)
• The POWER switch is set to VTR.
m Set it to CAMERA. (p.10)
• The tab on the cassette is out (red).
m Use a new tape or slide the tab. (p.9)
If you run into any problem using the camcorder, use the following table to
troubleshoot the problem. Should the difficulty persist, disconnect the power source
and contact your Sony dealer or local authorized Sony service facility.
Camcorder
Power
Symptom
The power is not on.
The power goes off.
The battery pack is quickly
discharged.
The beep sounds when the battery is
attached.
START/STOP does not operate.
(to be continued)