Filter
Top Products
38
CCD-TR2300/TR3300 3-856-204-23 (1)
You can insert a scene in the middle of a recorded tape by setting the starting and
ending points. The previous recorded portion will be erased. If the RC time code
appears in the viewfinder, set COUNTER to NORMAL in the menu system to display
the tape counter.
(1) While the camcorder is in Standby mode, keep pressing the + (forward
playback) or – (reverse playback) side of EDITSEARCH, and release the button
where you want to end the insertion [b]. The camcorder enters Standby mode
again.
(2) Press COUNTER RESET. The counter resets to zero.
(3) Keep pressing the – side of EDITSEARCH and release the button at the point
where you want to start the insertion [a].
(4) Press ZERO MEM on the Remote Commander. The ZERO MEM indicator
flashes.
(5) Press START/STOP to start recording. The recording stops automatically at
the counter zero point.
To change the end point
Press ZERO MEM to erase the ZERO MEM indicator, then repeat steps 2 to 5.
Note on re-recording
The picture and the sound may be distorted at the end of the inserted portion when it is
played back.
Re-recording a picture in the middle of a
recorded tape
[a]
[b]
L
S
T
A
N
D
B
Y
O
C
K
STBY
ZERO MEM
-0:01:22
5
1
3
EDITSEARCH
Œ
EDITSEARCH
Œ
4
ZERO MEM
STBY
ZERO MEM
-0:01:23
2
STBY
0:00:00
COUNTER RESET