Filter
Top Products
66
CCD-TR2300/TR3300 3-856-204-23 (1)
Notes on Date Search and Date Scan mode
• If a day’s recording is not longer than 2 minutes, the camcorder may not accurately
find its boundaries.
• Date Search and Date Scan do not function on a tape recorded by a camcorder
without the Data Code function. Your camcorder has the Data Code function.
• When searching the boundaries of date on the tape, the forwarded or reversed
picture appears in the viewfinder. Visual noise also appears during this searching.
This is not a mulfunction.
Searching the boundaries of recorded date
Returning to a pre-registered position
Using the Remote Commander, you can easily go back to the desired point on a tape
after playback. Use the tape counter. If the RC time code appears in the viewfinder, set
COUNTER to NORMAL in the menu system to display the tape counter.
(1) During playback, press COUNTER RESET at the point you later want to locate.
The counter shows “0:00:00” in the viewfinder.
(2) Press π when you want to stop playback.
(3) Press ZERO MEM on the Remote Commander. The ZERO MEM indicator
flashes in the viewfinder.
(4)
Press 0 to rewind or press ) to fast-forward the tape to the counter’s zero
point. The tape stops automatically when the counter reaches approximately zero.
REW
3
0
0:00:00
31
4
2
0:12:34
ZERO MEM
STOP
ZERO MEM
COUNTER RESET
Notes on the tape counter
• Something must be recorded on the tape in order for the tape counter to function.
Tape counter does not work on a blank tape.
• There may be a discrepancy of several seconds from the actual time.
Notes on ZERO MEM
• When you press ZERO MEM, the counter’s zero point is memorized. Press ZERO
MEM again before rewinding to cancel the memory.
• This function is cancelled automatically once the tape is rewound or advanced to the
point you pre-registered.
• ZERO MEM does not function during recording or playing back.