Filter
Top Products
6
CCD-TR2300/TR3300 3-856-204-23 (1)
Charging and installing the battery pack
Before using your camcorder, you first need to charge and install the battery pack. To
charge the battery pack, use the supplied AC power adaptor.
This camcorder operates with the “InfoLITHIUM” battery labeled such as
NP-F530/F730. If you use any other battery to operate your camcorder, the camcorder
may not operate or the battery life may be shortened.
“InfoLITHIUM” is a trademark of Sony Corporation.
Charging the battery pack
Charge the battery pack on a flat surface without vibration.
(1) Connect the power cord to a wall outlet.
(2) Align the surface of the battery pack indicated by the z mark with the edge of
the terminal shutter of the AC power adaptor. Then fit and slide the battery
pack in the direction of the arrow. The CHARGE lamp (orange) lights up.
Charging begins.
When charging is completed, the CHARGE lamp goes out. If the battery pack is used
right after the CHARGE lamp goes out, it will last for a normal period (normal charge).
If allowed to charge for an additional hour or so, the battery pack will last for a longer
period (full charge). Unplug the unit from the wall outlet, then remove the battery pack
and install it into the camcorder. You can also use the battery pack before it is
completely charged.
AC-V315 for CCD-TR3300 for Canadian model
Getting started
1
2
AC-V316/V316A for CCD-TR3300 for other than Canadian model and
CCD-TR2300
21