Filter
Top Products
161
Viewing Images Using your Computer
Connecting your camcorder to your computer using the USB cable
(For Windows users)
If you cannot install the USB driver
The USB driver has been registered incorrectly as your computer was connected to your
camcorder before installation of the USB driver was completed. Perform the following
procedure to correctly install the USB driver.
Viewing images recorded on a tape
Step 1: Uninstall the incorrect USB driver
1 Turn on your computer and allow Windows to load.
2 Connect the AC power adaptor, and set the POWER switch to VCR.
3 Connect the USB connector on your computer to the
(USB) jack on your
camcorder using the USB cable supplied with your camcorder.
4 Open your computer’s “Device Manager”.
Windows XP:
Select “Start” t “Control Panel” t “System” t “Hardware”, and click the
“Device Manager” button.
If there is no “System” inside “Pick a category” after clicking “Control Panel”,
click “Switch to classic view” instead.
Windows 2000 Professional:
Select “My Computer” t “Control Panel” t “System” t “Hardware” tab,
and click the “Device Manager” button.
Windows 98SE/Windows Me:
Select “My Computer” t “Control Panel” t “System”, and click “Device
Manager”.
5 Select and delete the underlined devices below.
Windows 98SE
Windows Me