Filter
Top Products
28 (GB) Chapter 2 Operation
Chapter 2
Selection
C.SYNC
WEN
Function
Outputs the composite sync signal.
Outputs the WEN signal. When connecting peripheral
equipment, the signal is used as trigger pulse output to
the equipment.
Select the polarity of the WEN signal with the
POLARITY setting.
: Negative
: Positive
Adjusting and Setting with Menus
Setting item
(VBS lock)
H. PHASE*
SC. PHASE ROUGH*
SC. PHASE FINE*
(HD/VD lock)
H. PHASE*
Contents of setting
Adjusts the horizontal phase and
SC (subcarrier) phase during
external synchronization (with
VBS signal input).
Adjusts the horizontal phase
during external synchronization
(with HD/VD signal input).
Ref. page
29
29
* Displayed only when an external sync signal is input.
BAUD RATE
Switches the baud rate of the REMOTE connector at the
rear panel.
Sets to any of 19200, 9600, 4800, 2400 and 1200.
Normally, set to 9600 when the RM-C950 remote control
unit is connected to the REMOTE connector.
Note
When the CMA-D3/C3CE is connected to the camera using
the CCMC-3MZ connecting cable, “CMA-D3” will appear
and you cannot select the baud rate.
Selection
VBS
Y/C
Function
Outputs VBS signal.
Outputs Y/C signal.
D-SUB VIDEO
Switches the video signal output from the RGB/SYNC
connector (D-sub 9-pin) at the rear panel.
Note
When the CMA-D3/C3CE is connected to the camera with
the CCMC-3MZ connecting cable, the item does not
function.
D-SUB SYNC
Switches the sync signal output from the RGB/SYNC
connector (D-sub 9-pin) at the rear panel.
Note
When the CMA-D3/C3CE is connected to the camera with
the CCMC-3MZ connecting cable, this item is fixed to
WEN.